281-407-6913 llplumbing@hotmail.com
Katy Water Heater Odor Repair

Are you experiencing problems with foul-smelling odors coming from the water originating from your water heater? It happens from time to time for a few various reasons. Here is what Water Heater Repair Katy TX suggests to do to make sure your water smells significantly better and to eliminate any undesirable tastes fast.

Reasons for Katy Water Heater Smells?

Bacteria entering into the water system is the most typical explanation ones water in the home could have smells. If you home utilizes well water or cities that utilize wells for the water supply, increases the chance of this taking place.

With a water heater temperature level setting of 140 degrees or more will assist in reducing the development of microorganisms inside of the water storage tank.

Ways to Eliminate Stinky Water Odors

The following instructions discuss the best way to use chlorine bleach to wash a water heater.

The electric or gas leading to the water heater tank has to first be shut off.

Next, the cold water supply off that goes to the tank needs to be turned off.

Open the hot water faucet of the kitchen sink to enable air to get in the tank.

With a a yard hose connected to the storage tank drain valve, drain the water inside the water heater.

Then shut the drain valve after it is empty.

The next step is putting in the bleach.
If the hose for the cold water going in the storage tank is a flexable line, unscrew it from the tank. Otherwise, one will likely need to take off the pressure relief valve, which is more involved. For electric water heaters, one of the elements can be removed.

Utilize a funnel to put bleach within the tank.
Use 5 ounces of bleach for each gallon of the tank capability.
So if you have a 50 gallon water heater, you will require 250 ounces of bleach, or close to 2 gallons.

Re attached the water line or pressure relief valve.

Fill the tank back up with water again.

Shut the hot water faucet of the kitchen area faucet as quickly as all the air runs out the line.

Operate all the hot water appliances up until the odor of bleach is noticeable. We want to eliminate the bacteria that are located in the water lines likewise, not only inside the water heater.

Let the water to stand in the tank and water lines undisturbed for 2 to 3 hours.

Empty the storage tank once again and refill it. This time allow it to set for at least thirty minutes and yet again drain it.

Fill the tank back up. Open all the hot water fixtures and let them run until the odor of bleach is gone.

For gas water heaters, relight the water heater pilot burner. For electric water heaters, turn the electricity on once more.

Additionally, by replacing the anode rods, or perhaps the type employed can work as the next video shows:

Odors from Katy Water Heater

What the Experts Say

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Soquel Creek Water District

How is hydrogen sulfide gas produced in a water heater?

A water heater can provide an ideal environment for the conversion of sulfate to hydrogen sulfide gas. The water heater can produce hydrogen sulfide gas in two ways – creating a warm environment where sulfur bacteria can live, and sustaining a reaction between sulfate in the water and the water heater anode.  Read more…

Minnesota Department of Health

Check out some of our other water heater tips in our blog